Mercedes S-Class W-220

since 1998 release

Repair and operation of the car


Mercedes W220
+ Mercedes-Benz cars of the class S (W220)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
- Automatic transmission
   Problems of the block of electronic control and the operating signals
   Search of malfunctions - the general information
   Removal and the AT installation with the hydrotransformer
   The AT electrohydraulic control unit (AT is established)
   Dismantling and assembly of the electrohydraulic control unit
   Dismantling and assembly of a plate of gear shifting
   Case of transmission and hydrotransformer
   Multidisk brakes of V2, VZ and gear wheel of blocking at "Parking"
   Dismantling and assembly of a back hollow shaft with the back coupling of a free wheeling
   Removal and installation of a multidisk brake B1 and oil pump
   Dismantling and assembly of the oil pump
   Dismantling and assembly of a multidisk brake of B1
   Dismantling and assembly of a multidisk brake of B2
   Dismantling and assembly of an output shaft with the central and back block of planetary gear wheels
   Removal and installation of multidisk couplings K1, K2 and K3
   Dismantling and assembly of coupling of K1
   Dismantling and assembly of the leading shaft with coupling by K2 and the forward block of planetary gear wheels
   Dismantling and assembly of coupling of K3
   The blocking mechanism at "parking"
   Removal and installation of the lever of the selector of gear shifting
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment



Multidisk brakes of V2, VZ and gear wheel of blocking at "Parking"

2 — the transmission Case
11 — Bolts
14 — the Multidisk brake of B2
15 — a blocking Gear wheel at "Parking"

133 — the Multidisk brake
VZ, 133a — the Lock ring
133b — Spring laying


Check of a gap "L" in a multidisk brake of VZ

2 — the transmission Case (an external support of a brake of VZ)
14a — the Piston
133a — the External disk 6.5 mm thick
133b, 133s — External disks 1.8 mm thick

133d — the Disk spring
133e — Frictional disks
133f — the Lock ring
"L" — the Gap


Dismantling

 PERFORMANCE ORDER

1. Remove the transmission from the hydrotransformer.
2. Remove a multidisk brake of VZ 133 and spring laying 133b, having taken out a lock ring 133a from the transmission case.
3. Turn off bolts 11.
4. Take a multidisk brake B2 14 of the transmission case.
5. Remove a blocking gear wheel at "Parking" 15.


Assembly

 PERFORMANCE ORDER

1. Assembly is carried out as it should be, the return to dismantling. Check and measure a gap in a multidisk brake of VZ. A gap "L" in a multidisk brake of VZ: 1.0 - 1.4 mm.
2. Establish VZ brake disks together in the order presented on an illustration and insert them in turn. Measure a gap of "L" between a lock ring 133f and an external disk 133a in three points. During measurement the lock ring 133f has to concern the top ring of the bearing in a groove of an external support of a brake 2.
3. Adjust a gap by means of lock rings 133f if it is necessary. Thickness of lock rings: 3.2, 3.5, 3.8, 4.1, 4.4 and 4.7 mm.