Mercedes S-Class W-220

since 1998 release

Repair and operation of the car

Dismantling and assembly of coupling of K1


83a — the External support of coupling K1 83b — the Sealing ring 86 — the Piston 86a — the Sealing ring of the piston 86b — the Disk spring 87 — the Spring plate	87a — the Sealing ring of a spring plate 88, 90 — Lock rings 89 — the Block of disks 91 — the Lock ring of the coupling of a free wheeling 92 — the Forward coupling of a free wheeling And — the Oil channel for coupling of K1

Check of a gap between a lock ring 90 and an external disk 89c


83a — the External support of coupling K1 86 — the Piston 86b — the Disk spring 89a — the External disk (thickness of 1.8 mm) 89b — the External disk (thickness of 3.5 mm / new thickness is 2.8 mm)	89s — the External disk (thickness of 4.0 mm) 89d — Frictional disks 90 — the Lock ring "L" — the Gap

Dismantling

PERFORMANCE ORDER

1. Remove a lock ring 90 from an external support.
2. Remove the block of disks 89 from an external support.

3. Establish a stripper 072 on a spring plate 87 and squeeze it until the lock ring 88 is not released.

4. Remove a disk spring 86b and the piston 86, having given to an opening And compressed air.

Assembly

PERFORMANCE ORDER

Assembly is carried out as it should be, the return to dismantling. Check a gap between a lock ring 90 and an external disk 89c. The size of gaps in coupling of K1 is specified in the table. Adjust a gap by means of a lock ring 90. Thickness of a lock ring: 2.6, 2.9, 3.2, 3.5, 3.8 and 4.1 mm.