Seats
Adjustment of provision of front seats
There is a danger of traumatizing!
Provisions of a body when sitting at which the correct prileganiye of seat belts is broken aggravates risk factors and therefore they should be avoided.
The back should be established almost vertically. The back has to adjoin to a back, and a seat belt - to a humeral zone.
Establish a head restraint so that the nape found on it an emphasis approximately at the level of eyes.
At adjustment of provision of seats you watch that nobody was jammed.
As well at a short-term exit from the car take out an electronic key from the lock of ignition or take with yourself a smart card.
Adjustment of provision of sitting, however, is possible also at one open door.
Therefore do not leave children in the car unguarded. There is a danger of accident!
For reasons of safety it is impossible to change the provision of a seat during the movement.
Turn an electronic key in the lock of ignition in situation 1 or 2.
At an open door of the driver adjustment of provision of a seat of the driver can be made at the inserted electronic key.
Adjustment of provision of a seat of the forward passenger can also be made at one open door.
|
|
If adjustment of provision of a seat is made from situation for lying or from far removed situation, watch that back cosmetic mirrors were closed. |
Switches are in forward doors.
We recommend to make the main adjustment as follows:
1 Longitudinal movement of a seat
You translate the switch in the direction of an arrow before convenient achievement of a pedal of an accelerator.
|
|
If in a safety grid for baggage in space for legs of the passenger there are objects, do not rearrange a seat of the forward passenger forward completely - pieces of baggage can be damaged. |
2 Press the button E
The car with memory function
Hold the button E pressed until all adjustments of situation are executed.
It is a step will facilitate to you adjustment of provision of seats. All other provisions of seats, mirrors (driver's seat) and a steering wheel (the driver's seat) are established automatically depending on the established longitudinal provision of a seat. After that it is necessary to execute only its exact adjustment as it is described below. External rear-view mirrors, an internal rear-view mirror and a steering wheel are described in the Section the Steering wheel, rear-view mirrors.
Seat height
You translate the switch behind in the direction of an arrow until the highest situation at preservation of rather free space over the head is reached.
Seat inclination
You translate the switch in front in the direction of an arrow before achievement of the situation providing easy support of hips.
Back inclination
You translate the switch forward or back until the hands lying on a steering wheel are not slightly bent in elbows.
Seat pillow contour
You translate the switch forward or back before achievement of the situation providing easy support of hips.
Height of head restraints
Height of head restraints automatically is established at adjustment of provision of seats so that the nape found an emphasis on a head restraint approximately at the level of eyes. If this situation is not reached automatically, adjust a head restraint by means of the switch.
-1-adjust an inclination of a head restraint manually. Pull or press a head restraint in front.
(Record in memory of provision of a seat — address the Section Memory of Provision of a Seat).
Removal and installation of head restraints of a seat of the driver and seat of the forward passenger
There is a danger of traumatizing!
Move only with the established head restraints.
|
|
For simplification of removal and installation of a head restraint slightly incline a seatback. |
Removal
Move the switch-1-up to that time until the head restraint is put forward completely. Extend a head restraint.
Installation
Move the switch-1-up approximately for 5 seconds.
Press a head restraint down to fixing.
Lumbar support
Regulators are sideways in front on a seat of the driver and a seat of the forward passenger and sideways on back seats.
For support of a backbone it is possible to adjust camber of a back.
Turn an electronic key in the lock of ignition in situation 2.
Establish by the regulator-1-camber of a back between situation 0 and 5.
Multiplanimetric seatback
Seat of the driver and seat of the forward passenger:
The switch is sideways in front on a seat.
For support of a backbone individual installation of a contour of a back is possible.
Turn an electronic key in the lock of ignition in situation 2.
Back seats
The switch is sideways on a seat.
It is recommended to make basic installation in the following sequence:
1 Camber of a back in a waist zone
2 Camber of a back in a back zone (only a seat of the driver and a seat of the forward passenger)
Switches 1 and 2:
Press the switch from above and hold pressed, separate airbags are consistently inflated from top to down. At achievement of required position release the switch.
Press the switch below and hold pressed, separate airbags are consistently inflated from below up. At achievement of required position release the switch.
3 Side parts of a back
Press the button to the right or to the left, side support amplifies or weakened. Establish side parts of a seatback so that good side support was provided.
4 Dynamic function (PULSE)
In order to avoid the constant tension of muscles during a long trip the multiplanimetric seatback is supplied with dynamic function.
At the same time the mumpish airbag in a back is rhythmically inflated and then dumps pressure.
At the included dynamic function the control light-emitting diode on the switch burns. Approximately in 5 minutes dynamic function is automatically switched off.
|
|
If the most top airbag is inflated, the average airbag is inflated, and pressure is dumped. |
Heating of seats
Turn an electronic key in the lock of ignition in situation 1 or 2.
Notes: At inclusion of too large number of consumers of the electric power or insufficient state of charge of the rechargeable battery the heating system of seats can be disconnected. In this case blinks one or both control light-emitting diodes.
At restoration of sufficient tension the heating system of seats joins automatically.
Buttons are on the corresponding door.
Models without ventilation of seats
Press the button-1-.
The red control light-emitting diode over the button burns. Mode of normal heating.
In about 30 minutes the heating system of seats is automatically switched off.
Press the button-2-:
Both red control light-emitting diodes over the button burn. Mode of the maximum heating.
In about 5 minutes automatic switching to the normal mode of heating is made.
Press the button-1-or-2-once again:
Any control light-emitting diode does not burn.
The heating system of seats is switched off.
Buttons are on the corresponding door.
Models with ventilation of seats
Press the button-3-.
Both red control light-emitting diodes over the button burn. Mode of the maximum heating.
In about 5 minutes automatic switching to the normal mode of heating is made.
Press the button-3-once again:
The red control light-emitting diode over the button burns. Mode of normal heating.
In about 30 minutes the heating system of seats is automatically switched off.
Press the button once again:
Any control light-emitting diode does not burn.
The heating system of seats is switched off.
Ventilation of seats
Buttons are on the corresponding door.
Ventilation of seats can be activated manually or system of opening in summertime of year (the driver's seat) (Undressed Locks, keys and locks. Smart card. Uniform lock).
If the system of ventilation of seats is activated by system of opening in summertime of year, the maximum step of ventilation automatically is established.
Activation manually
Turn an electronic key in the lock of ignition in situation 1 or 2.
Press the button-1-.
3 blue control light-emitting diodes over the button light up. Mode of the maximum ventilation (step 3).
Approximately each 10 minutes automatic switching to lower step of ventilation is made.
Press the button-1-once again:
2 blue control light-emitting diodes over the button light up. Average step of ventilation (step 2).
Press the button-1-once again:
One blue control light-emitting diode over the button burns. Mode of the lowest step of ventilation (step 1).
Press the button-1-once again:
Any control light-emitting diode does not burn.
The system of ventilation of seats is switched off.
|
|
At inclusion of too large number of consumers of the electric power or insufficient state of charge of the rechargeable battery the system of ventilation of seats can be disconnected. In this case one or several control light-emitting diodes blink.
At restoration of sufficient tension the heating system of back glass joins automatically. |
Head restraints of back seats
The switch is on the average console.
There is a danger of traumatizing!
If back seats are occupied, move only with the established head restraints. Thereby the risk of getting injured by back passengers at accident is reduced.
Turn an electronic key in the lock of ignition in situation 1 or 2.
Tilting
Quickly press the switch a symbol.
Installation up
Cast away a head restraint manually up to fixing.
Inclination
The inclination can be regulated manually.
Pull or press a head restraint in front.
Head restraints of back seats (automatic)
There is a danger of traumatizing!
If back sitting are busy, move only with the established head restraints. Thereby the risk of getting injured by back passengers at accident is reduced.
|
|
In cars with 3 places for a seat behind the average head restraint cannot automatically be established. Manually cast away it up to fixing. |
At a busy seat (a belt in the belt lock) head restraints of both extreme seats are established automatically.
You watch that process of the movement of head restraints was not interfered by objects (for example, clothes).
The switch is located on the average console.
Turn an electronic key in the lock of ignition in situation 1 or 2.
Press the switch:
1 Tilting back
2 Installation up:
Both extreme head restraints are established or lean back together. In the presence of 3 head restraints in a back part of salon the average head restraint also leans back.
Switches are on the corresponding back door.
1 Installation up
2 Tilting back
The corresponding extreme head restraint can be established up or lean back back.
The inclination of a head restraint can be regulated manually. Pull or press a head restraint in front.
Adjustment of provision of back seats
There is a danger of traumatizing!
Provisions of a body when sitting at which the correct prileganiye of seat belts is broken aggravate risk factors and therefore they should be avoided.
The back should be established almost vertically. The back has to adjoin to a back, and a seat belt — to a humeral zone.
As well at a short-term exit from the car take out an electronic key from the lock of ignition or take with yourself a smart card.
Adjustment of provision of a seat, however, is possible also at one open door. Therefore do not leave children in the car unguarded.
Turn an electronic key in the lock of ignition in situation 1 or 2 (and if one of doors as well at the taken-out electronic key or at the provision of a key 0 is open).
Models with a many-placed back seat
Switches are on the corresponding back door.
1 Longitudinal movement
Press the switch forward or back. At the same time the back inclination is at the same time regulated.
2 Height of head restraints
Pull the switch up or press down. The head restraint is established up or leans back back.
Models with separate back seats
Switches are on the corresponding back door.
1 Longitudinal movement
Press the switch forward or back.
At the same time the back inclination is at the same time regulated.
2 Seat pillow inclination
Pull the switch up or press down.
3 Head restraint
Pull the switch up or press down.
Adjustment of provision of a seat of the forward passenger from a back part of salon
The switch is on the right back door.
Turn an electronic key in the lock of ignition in situation 1 or 2.
Press the button-1-, adjust the provision of a seat of the forward passenger:
3 Longitudinal movement
4 Back inclination
5 Lowering of a head restraint down
6 Seat height
Adjustment of provision of a back seat
Press the button-2-and adjust the provision of a back seat:
Address the above-stated materials of this Section.
|
|
If in a safety grid for baggage in space for legs of the forward passenger there are objects, do not rearrange a seat of the forward passenger forward completely — pieces of baggage can be damaged. |
|