Mercedes S-Class W-220

since 1998 release

Repair and operation of the car



Mercedes W220
+ Mercedes-Benz cars of the class S (W220)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Automatic transmission
+ Power shafts
+ Brake system
- Suspension bracket and steering
   Security measures
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      The angles of installation of wheels of the car - the general information
      Conditions of check of angles of installation of wheels
      Adjustment of forward wheels
      Adjustment of back wheels
      Check of clearance of a body of the car
      Removal and installation of the steering mechanism
      Pump of the amplifier of steering
      Dismantling and assembly of the pump of the amplifier of steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the lower steering shaft
      Removal and installation of the drive for telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe
      Removal and installation of the blocking cylinder
      Contact spring
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment





Removal and installation of the drive for telescopic adjustment of a steering column

Removal

 PERFORMANCE ORDER

1. Turn off a bolt 84 and take the telescopic M20m1 drive.

2. Remove the blocking device 84b and take a finger 84a from an external pipe 81a.

3. Remove the telescopic drive of adjustment M20m1.


Installation

 PERFORMANCE ORDER

1. Install the telescopic M20m1 drive on an external pipe 81a and implant a finger 84a.
2. Fix the blocking device 84b.

3. Using the indicator 22, adjust a pipe gap. For this purpose move the telescopic M20m1 drive and a bolt 84 to an oblong opening so that the gap was reached. The gap has to be within 0.25 - 0.30 mm.

4. Tighten a bolt 84.